Saturday, December 10, 2011

Off-Season Marine Battery Care

Robert M. Hohman
Complete Battery Source, Inc.

One of the most frequently asked questions we receive at Complete Battery Source is “ What should I do with my marine batteries during the winter months?” Off- season battery care is perhaps the most important factor in getting the most service life from your batteries.

The worst thing to do is nothing at all. Batteries that are left with no type of winterization may survive to fish again, but will most likely be damaged to the point that performance and overall life will be drastically reduced. 

All batteries both wet and “dry” or AGM batteries lose a small percentage of charge everyday. When this occurs, a crystal like substance known as lead sulfate forms on the plates. These crystals reduce and even block the flow of energy through the battery. A partially sulfated battery will still charge and even show that it is fully charged; however, runtime and or cranking performance will be diminished. A sulfated battery can be recognized by it’s “swollen” appearance. The sides of these batteries will be noticeably bowed out. In more severe situations, the plastic case around the posts will appear to pushing up from the inside. 

Batteries that are left connected are even more prone to sulfating. Minute parasitic loads caused by electronics, fuel injection, and engine control systems increase the rate of discharge. Discharged batteries are also more likely to freeze during the winter months. While a fully charged battery will not freeze until the temperature drops to –38 degrees Fahrenheit, a fully discharged battery will freeze at 32 degrees Fahrenheit. Frozen batteries will often have cracked or split cases.

At the very minimum, batteries should be fully charged then completely disconnected and left in the boat for storage. These batteries should then be charged for twenty-four hours minimum before the first trip in the spring. Contrary to popular belief, storing the batteries in a heated environment is not beneficial.

Batteries are nothing more than a contained and controlled chemical reaction. As with any chemical reaction, heat increases it’s speed. In fact, a fully charged battery stored at a constant 78 degrees Fahrenheit will lose 80% of its charge within 45 days while the same battery stored at 32 degrees Fahrenheit will take many months to lose the same 80%.

Many fishermen will store their boats with their on-board chargers left on. This practice can have varying affects depending on the charger. Some chargers will merely charge the batteries, and then turn off, leading to a discharged battery. Others will switch to a lower amperage charge, but will eventually over charge, causing fluid loss and battery plate degradation, leading to premature failure. Batteries that have been over charged will sound hollow when their sides are tapped. You may also notice fluid in the battery box or tray. For batteries that have removable caps, a visual inspection will show that the fluid has dropped below the now exposed plates. If your only option is to use your on board charger, we recommend that you plug the charger in once per month for four to six hours.

The best method for maximizing battery life is to use a battery maintainer. These devices are very popular and many brands are available. As with any marine equipment all maintenance chargers are not created equal. At Complete Battery Source, we have found a charger manufactured by CTEK to be one of the most advanced and effective for charging and maintaining both traditional wet batteries and dry cell AGM types. A link to the CTEK website can be found on our website at www.CompleteBatterySource.com

The CTEK chargers range in price from $44.95 to $119.95. The CTEK chargers use a three step charging cycle, including a pulse maintenance mode to rid the battery of minor lead sulfate build up on the plates.

Before storing you batteries you should, if possible, check the fluid levels. The fluid should be just covering the plates but not touching the inner wall of the fill hole. If fluid addition is necessary use distilled water. 

Next fully charge your batteries using your normal charging method. After charging make certain that the top of the battery is clean and dry. If your boat is stored where no power is available, remove your batteries and take them to your garage or basement for storage. 

You can also maintain multiple batteries with one maintenance charger as long as they are of the same size and type. The batteries should be connected in parallel, meaning positive posts connected together and negative posts connected together. Connect the batteries together using #6 or larger wire with alligator clips or ring terminals. Connect the charger and you are finished for the season. The batteries will be ready to reinstall in the spring. 

If connecting the batteries in parallel is too complicated, or just too much trouble for you, a single small charger can be used for each battery, or one charger can be rotated from battery to battery every few weeks. The second method will obviously require more work on your part.

Following these relatively simple steps, you can get the maximum service life from your batteries and more trouble-free time on the water. 

As always, should you have any battery related needs or questions feel free to call or stop in to any of the five Complete Battery Source locations in Brighton, Detroit, Okemos, Ypsilanti, or Houghton Lake/ Prudenville.

Tuesday, November 15, 2011

PowerSports Battery Pricing Going Up!

Environmental concerns in China have caused a halt in battery production for several Chinese manufacturers. High levels of lead have been found in more than 300 residents in one county, forcing the Chinese Ministry of Environmental Protection to issue warnings to the battery factories. Labor and raw materials costs are also increasing.
As a result, the cost of PowerSports batteries will be increasing. Before the increase hits, however, we still have some batteries in our warehouse available at our current cost. We are encouraging you to stock up on your PowerSports batteries now, as they may be in short supply for a while as the Chinese manufacturers meet the environmental standards of their government.

Look for these PowerSports batteries on-line at CompleteBatterySource.com"Yep...Got That!"

Tuesday, October 25, 2011

Complete Battery Source and Soda Pop Jr. Pizza Team up for “Change your Clock Change Your Battery”


The time to change your clock and change your battery is here again.  On November 6th 2011 at 2:00 am we will be setting our clocks back one hour, marking the end of Daylight Savings time for 2011.  People are also encouraged to take this time to change the batteries in their home’s smoke detectors as well. In the event of a house fire, the early warning provided by these devices save lives. Complete Battery Source of Brighton , has teamed up with Soda Pop Jr. Pizza, in an effort to remind people to change their smoke detector batteries.  From Friday evening November 5th through Saturday evening November 6th Complete Battery Source will provide 1 free 9-volt battery with each order, placed at Soda Pop Jr.’s Pizza, picked up or delivered.  Along with the battery, customers will receive a fire safety flyer with five tips to prevent fires in the home.

     Each year Complete Battery Source provides smoke detector batteries to families in the area.  “This is the first year we have been able to take the batteries right to people’s homes”, said Rob Hohman, Vice President of Complete Battery Source. 

According to the Fire safety council:

 Fewer people die in home fires when a smoke alarm/detector is present and activates:
- Smoke Alarm Present and Activated: 12 deaths/1000 home fires
- No Device / Alarm Did Not Activate: 17 deaths/1000 home fires

In some fires where people died, smoke alarms were present but did not activate. In 85% of the cases where the smoke alarm did not activate, it was due to a dead or missing battery/power source.

For more information please contact Rob Hohman, Complete Battery Source 734-320-1516

Monday, March 14, 2011

Need another battery bank? Look at the GEN2 On-Board Battery Charger by NOCO Genius

The GEN2 on-board battery charger offers the perfect mix of high-technology and rugged construction. With a fully-sealed, waterproof housing, the GEN2 can be mounted directly onto a variety of applications including boats, tractors and a wide range of equipment. With the intelligent NOCO VosFX processor constantly monitoring the power input, attached battery and charger itself, the GEN2 charger is capable of diagnosing, recovering, charging and maintaining batteries.

These chargers are fully sealed and waterproof. They charge batteries 2 times faster than traditional linear battery chargers. The GEN2 is also designed for safety. They are designed to protect from reverse polarity, short circuits, open circuits, overcurrent, overheat and overcharging.

GEN2 Technical Specifications

Battery Banks2
Amps/Bank10A
Total Amps20A
Input Voltage AC110-120 VAC, 50-60Hz
Working Voltage AC70-130 VAC, 50-60Hz
Nominal Voltage12-24VDC
Efficiency90%
Charging Voltage14.4V
Back Current Drain<1mAh
Ripple<2%
Charger Type8 Step, Fully Automatic,
Switch-Mode
Type of Batteries12V Lead-Acid
Battery ChemistriesWet, Gel, MF & AGM
Battery Capacity25-230Ah
Housing ProtectionIP 68
CoolingNatural Convection
Output Leads (Length)6 Feet
AC Cord (Length)5 Feet
Dimensions (L x W x H)7.0 x 6.0 x 2.5 Inches
Weight5.7 Pounds


*Meets ISO 8846 Marine standards and Ignition protected (US Coast Guard 33 CFR 183.410)
What's in the Box?
  • GEN2 Charger
  • Owner's Manual & User Guide
  • Product Registration Card
 Charging Times

The time required for the GEN2 to charge a normally discharged battery is shown below. Deeply discharged batteries may take longer to charge depending on the depth of discharge (DOD). The charge time is based on an average depth of discharge to a fully charged battery.

* Note: the above table is for reference purposes only. Actual data may differ due to battery conditions. The time required for the GEN2 to charge a normally discharged battery is based on an average DOD of 50%.

Charging Steps

Steps 1 & 2: Test & Diagnostics
Checks battery voltage to make sure battery connections are good & battery is in a stable condition.

Step 3: Soft Start
Begins Bulk charging process with a gentle (soft) charge.

Step 4: Bulk
Continues Bulk charging process, returns 80% of battery capacity.

Step 5: Absorption
Switches to a constant current charge rate to bring your batteries close to 90% charge.

Step 6: Taper
Charges at low current levels until battery has reached 95% of its capacity.

Step 7: Top-Off
Charger initiates top-off charge to bring the battery to 100% charge.

Step 8: 24 Hour
Shuts off, but constantly monitors your battery by providing a gentle charge every 24 hours for maximum battery life.